Read What Others Are Saying

over now easy to do good but the colors result does not correspond to the photo, evaluation5 stars

since the needle hole is in front of sewers do not understand how it is possible to thread the needle with the commissioning of the machine side as in the picture, we made it by putting it in front cmq you lose time and have to take several attempts..

beautiful patterns, school x accomplish very clear points and amends x neophytes unfortunate that some works is listed as assemble..

and 'a very long time that I wanted to, taken advantage of the discount! really beautiful, useful, cut perfectly as all those of this company. I'm very happy to have them purchased. when andro 'on vacation the portero' always with me, given the usefulness 'of aere only one thing for more' functions..

I used it with mulin and frayed such that the wire unusable, I came to doubt that will work only with the sewing thread x..

I have it for many years and know a good strength and good ergonomics (light and snodabilissimo, it assumes any angle, front or side), although the screws, over time, tend to oxidize. Unfortunately for the use that I do not really suitable and should be reported: can not keep well the Q-snap frames. The vice tightens through two screws located right in the middle of the piece of wood, leaving only 2 cm deep where to place the frame. For round frames that have the flat edge and end I think there is no problem, especially since this a groove that helps to block them, but for frames with round profile, such as a problem q-snap. Are caught, of course, but could not go far behind are agguantati only by those two cm of wood resting on the round board, therefore, while by tightening its grip after just slip off and fall. They had to design the most wide grip, because it was actually used with any frame..